On the scale of plumbing problems, having no water in your home might be one of the worst issues you can have. But don’t panic! Our team here at Mallick Plumbing & Heating provides 24-hour emergency services for problems like these. We understand that it’s difficult to go without water in your home for long. If you need a plumber in Bethesda, MD you should contact our team. Our staff is always punctual, knowledgeable, and prepared for any problem you may have.
What You Should Do if Your House Has No Water
- Check Another Tap: Before you panic, make sure you’re thorough in your analysis of the problem. Your first step should be to check the other taps in your home. While one tap not working correctly is scary, it doesn’t immediately mean your entire house has shut down. If the problem is only with one tap the problem is much smaller but if you’re right about your suspicions and your entire house isn’t receiving water, then you’ll need the help of a professional plumber.
- Phone a Friend: Contact your next-door neighbors. If they’re also having trouble with water loss, then you’ve probably got a municipal water supply problem on your hands. You should call the water department to find out what the issue is and how long your supply will be out.
- Check Your Water Main: Check the location of your main shut-off valve. If you’re not getting any water in your home, it’s likely because of a problem with the water main. If you have an emergency shut-off valve, it could have accidentally triggered and stopped your water flow, or the valve could be open and impeding your water supply because it’s leaking.
If you still can’t determine why your home isn’t receiving water after going through these steps, it’s time to call a professional.
Possible Reasons Why Your Water Has Stopped Working
Outside of common mishaps like the ones above, there are other problems with your system that can cause a lack of water in your home. You can determine which of these issues is causing problems for your home with the help of a licensed plumber.
- A clogged tap connection: If your tap connection is old it can become full of sediment or susceptible to corrosion over time. In most cases, it’s better to completely replace this type of connection but in some cases, the connection can be cleaned and reconnected.
- Poor or Aged Materials: Our technicians can help you determine if this is your problem If your water lines are extremely old or incorrectly sized during installation is causes low water pressure and even a lack of water over time.
- Corroded or Clogged Pipes: When you think of a “clog” in relation to your pipes you might think of something caused by a backup of sludge or grime. The type of clog we’re detailing in this situation is due to a build-up of mineral residue along the inside of your pipe. We suffer from hard water here in Maryland that leaves ample mineral build up behind. If your home lacks water supply this could be the problem.
Call Mallick Plumbing & Heating
An issue with this type of impact needs an assessment from a professional. Our team here at Mallick Plumbing & Heating has served the Greater Washington Metro area for years and we can help you too.